cutting concrete on an angle Things To Know Before You Buy



Decorative Concrete of Austin
Austin, TX, USA
http://decorativeconcreteofaustin.com
+1 512-909-5812

1. You advocate glueing the foam board on the concrete. I used to be considering Placing Delte-FL involving the foam board as well as concrete

When you've got no use for the drain (dry basement) then I’d tape above it to seal it. Never try and plug it off when you may need it sometime. I’d create a Observe for yourself with the location just in case you have to have access to it in the future.

You suggested using 4-six screws for every Advantec board. Because it is usually a T&G, this means that screws really need to place pn the edges or you should place tapcons all around Every single board.

In ripping out the current floor I discovered the preceding homeowners lined up the drain. What it The easiest method to deal with the drain so that you can preserve the vapor block throughout the floor.

So far as your mechanical place it’s genuinely a matter of compromise. Do you need to remove the furnace? Most likely not, so it might sound right to depart the present insulation set up unless you suspect some kind of mildew dilemma.

two. I have a substantial space (600 sq. ft)which i approach to go away unfinished with storage and utilities and do not intend to insulate walls or floor (will depart builder installed insulation In this particular space on walls).

Seal all of the seams with the foam board insulation. We suggest you tape the seams with Tyvek (or equivalent) tape. You'll be able to seal along the walls with spray foam from a can (Fantastic Things or similar).

That is definitely some miracle stuff! Amazing, glad you for more about concrete staining austin bought the look you need for a very acceptable price! I like The brand new “track” that you will be on with your home …. can’t wait around to see the next challenge!

I posted a basement wall dilemma that you answered – thanks – now I've some questions re the floor (I haven’t performed the walls nonetheless).

2. I believe it’s certainly a achievable Remedy. I'd personally counsel heading over the small print of that with your heating/plumbing contractor. It truly wouldn’t be much different than installing the tubes on foam board below a concrete slab.

You can find a lot of solutions remaining sold now that are generally a mix of rigid foam insulation and some type of sub-floor materials like OSB.

Properly you would want to be aware of if there is a “Strip Footing” down the center (assuming This is when your wall is going). In some cases a contractor will pour a strip footing the complete size from the cutting concrete board circular saw house in place of trying to form up a footing pad at Every single column. The toughness of your concrete isn’t really the issue, it’s the thickness and depth of footing.

I actually enjoy the finished item. I feel your sponge painting The grey paint additional a nice touch. I don’t Imagine you could potentially have discovered a far better Remedy for the countertops!

3) I plan to tapcon/powder visit here for http://decorativeconcreteofaustin.com/ nail from the OSG and XPS into the floor. Is there a rule for the way deep into the concrete the screw/nail ought to go?

Leave a Reply

Your email address will not be published. Required fields are marked *